Skip to main content

Self-adhesive back

As slim as a supermodel: the tempusFLAT KLETT system from herotec is really thin with an installation height of just two millimetres. Its synthetic fibre layer is the perfect solution for the subsequent installation of a panel heating system - on any base. Strong: the hook-and-loop fastener between the tube and the synthetic fibre is unshakeable. All without extra tools or fastening points. Studded is a thing of the past. 

Short installation times - minimal offcuts.
Extremely economic.

Simple installation

Straight from the roll to the substrate and minimal offcuts: something the studded panel cannot match. The tempusFLAT KLETT system is the specialist for every modernisation project. Including the simplest possible installation. The fleece is trimmed to size with scissors or a cutter knife. The tube is securely fixed to the hook-and-loop fastener. Finished. One-man installation without special tools. That's how simple perfect modernisation can be.

 

 

To the data sheet

Get in touch

Simply economic

Environmentally friendly and fast: the tempusFLAT KLETT system scores points with minimal offcuts, little waste and effective one-man installation - without the need for special tools. This means: simple production of large areas with significantly reduced time. And noticeable cost minimisation for the building owner. Another benefit: up to 90 percent lower transport volume compared to conventional stud panel systems.

 

The result: excellent outcomes.
For building owners and fitters.

Simply adaptable

Especially quick and easy to install: the advantages of "slim heat" from the tempusFLAT KLETT system are obvious.
Different system variants always offer the right solution for different requirements. From the thin composite construction (installation height ≥ 15 mm plus top panel) to the slimline optimisation of footfall sound properties (up to 28 dB and minimum installation height 50 mm). The herotec system adapts precisely to individual needs.

 

tempusFLAT KLETT

tempusFLAT KLETT

With this solution, you can quickly and easily create an adhesive surface on insulation installed on site or directly on a solid substrate or wooden floor. The synthetic fibre matting, which is only 2 mm thick, is bonded to the substrate by the adhesive applied on the back. The hook and loop fastener tubes from the herotec range can then be fixed in place by one person working alone.

  • Self-adhesive back
  • Strong hook-and-loop fastener effect
  • Extremely low installation heights
  • Fast and simple installation
  • Tube spacing free to choose
A typical floor build-up
tempusFLAT KLETT DS

tempusFLAT KLETT DS

The perforated mats made of 2 mm thin synthetic fibre fabric can be easily cut and laid. The corresponding herotec pipes are glued on to the prepared substrate and then the thin-layer screed or smoothing compound is applied. The holes create a secure composite construction.

  • Strong bond with the base
  • Ideal for renovation
  • Installation heights possible from 15 mm
  • Self-adhesive back
  • Freely selectable pipe spacing
A typical floor build-up
tempusFLAT KLETT dB

tempusFLAT KLETT dB

This solution makes it possible to achieve an impact sound improvement of up to 28 dB with a minimum of effort. The roll consists of a synthetic fibre top layer with a thickness of just 2 mm and a strong hook and loop fastening effect. In addition, an 8 mm factory-installed acoustic underlay reduces impact sound.

  • Up to 28 dB footfall sound improvement
  • Floor build-up heights from 50 mm possible
  • Ideal for renovation
  • Reduced installation times
  • Freely selectable pipe spacing
A typical floor build-up

tempusFLAT KLETT

References

Private home


100 sqm ground floor
Laying directly on a bound fill

Private home


80 sqm
Laying directly on the floor slab